Product

Frequency Shaped Isotropic Electric Probes

PI-SH-FCC, PI-SH-ICNIRP

-

EMC Test Design, LLC

PI-SH-FCC, PI-SH-ICNIRP - EMC Test Design, LLC

An isotropic electric field probe with shaped frequency response meeting the ICNIRP or FCC RF safety standards for occupational and general public exposure limits (see the specified frequency ranges below). Meter readings are shown in % of the STD – standard reference level, eliminating the need to know the source frequency. Probe output is proportional to RF power density in the whole specified power range, producing the correct RF power measurements in single and multi-signal environments, typically present at multiple antenna sites.

Product

Frequency Doubling Comb Generator

COMBGEN6DIFF

-

Ultraview Corporation

COMBGEN6DIFF - Ultraview Corporation

*Differential output - can also provide two separate single ended complementary outputs.*Pulse height of up to +4V peak into 50 ohms, on positive output*Pulse height of up to -4V peak into 50 ohms, on negative output*Rise time < 80pS, FWHM of approximately 120pS*Produces pulse on both edges of input clock, thereby doubling frequency.*Input clock may be sinewave from 50MHz to 2GHz or square wave from 5MHz to 2GHz, producing fundamental comb tooth energy from 10MHz to 4GHz.*Usable energy to >10GHz.*Can drive any load, including short, without damage.*Power Requirements: -12V @ 120mA and +24V @ 80mA

Product

Standard Step Tablets, Gray Scales & Density Reference Charts

-

Applied Image, Inc.

Applied Image, Inc.

Standard Step Tablets, Gray Scales & Density Reference Charts are available in a wide variety of patterns, designs and sizes to fit a multitude of today’s application needs. Our gray scales and density patches are measured on a variety of NIST traceable instrumentation, including some of the most sophisticated microdensitometers available to the industry. They are imaged on either Photo Paper (RM) or Film (TM) to function for reflective or transmissive applications.

Product

Rubidium Oscillator

IQRB-2

-

IQD Frequency Products Ltd

IQRB-2 - IQD Frequency Products Ltd

The IQRB-2 low noise rubidium oscillator is a sub-miniature atomic oscillator combined with 'active noise filter' technology. This rubidium oscillator has 100 times less drift than OCXOs and with short term stability of 0.002ppb/s at 100s this rubidium oscillator provides significant improvements in performance over other rubidium components.

Product

Frequency Dividers

-

Pasternack Enterprises, Inc.

Pasternack Enterprises, Inc.

SMA SPDT electro mechanical RF relay switch features Indicators, Failsafe, Normally Open with an isolation minimum of 60 dB. SPDT electromechanical relay radio frequency switch PE71S6052 is part of over 40,000 RF, microwave and millimeter wave components available from Pasternack. Our SPDT SMA coaxial RF relay electromechanical switch can ship worldwide the same day that it is bought as with our other available RF parts.

Product

Turbidity And Standard Meters

-

HF Scientific

HF Scientific

Accurately measure the cloudiness of a fluid caused by suspended particles with turbidity meters and standards from HF scientific. Our turbidity meters and standards instruments include features that simplify installation, maintenance, and data access.We offer reliable turbidity meters including an online turbidity meter, handheld turbidity meter, and benchtop turbidity meter.

Product

Standard C23 20x30 Mm Photoelectric Sensors

-

Contrinex AG

Contrinex AG

Contrinex Standard C23 20x30 Mm Photoelectric Sensors

Product

Standard Current Transformers

-

Measurements International Ltd.

Measurements International Ltd.

Single Range, Highest Permeability, Wide Measurement Range, Negligible Current Errors, High Accuracy.

Product

FREQUENCY DISPLAY UNIT

TYPE NFD-1

-

National RF, Inc

TYPE NFD-1 - National RF, Inc

The National RF Type NFD-1 Frequency Display Unit was designed for use with vintage and classic communications equipment, to display the received or transmitted radio frequency. The unit incorporates an internal processor that allows the intermediate frequency (IF) to be counted out by the frequency counter. The resultant display is the actual frequency that the equipment is receiving or operating at.

Product

Frequency Doublers

-

Teledyne RF & Microwave

Teledyne RF & Microwave

Teledyne Microwave Solutions (TMS) offers several Frequency Doublers providing high fundamental suppression, broadband input/output frequencies, and low conversion loss figures for a variety of communications applications.

Product

Variable Frequency Modules

9554-( )

-

Solar Electronics Company

9554-( ) - Solar Electronics Company

Utilizing the high voltage power source in the Model 9354-1 Universal Transient Generator, four individual modules can be connected to provide tuning of damped sine waves from 10 KHz to 50 MHz. A fifth module is available which, when used in conjunction with the Model 9354-1, provides 20% frequency steps from 30 MHz to 100 MHz

Product

Series Low Frequency Vibration Sensors

AC136

-

Semapi Corp

AC136 - Semapi Corp

Low Frequency Accelerometer, Side Exit Connector / Cable, 500 mV/g

Product

Series Standard HV Capacitors

PMT10000

-

Power Measurement Technologies Inc.

PMT10000 - Power Measurement Technologies Inc.

High voltage, low dissipation factor, gas-filled Standard Capacitors for indoor use in a laboratory or production environment. A three terminal design configuration allows accurate measurements of capacitance and dissipation factor (tangent delta) with little or no effect from test lead or stray capacitance.

Product

Frequency Extenders

-

ERAVANT

ERAVANT

A frequency extender is an electronic device that allows high-fidelity analog audio to be sent over regular POTS telephone lines, without the loss of higher audio frequencies. It is an extended concept of a telephone hybrid.

Product

Absolute > Standard Encoders - Hollow Shaft

-

SCANCON

SCANCON

Absolute > Standard Encoders - Hollow Shaft

Product

Standard Round 2m Cables, Shielded, for Higher Current

ST010-S

-

TEAM SOLUTIONS, INC.

ST010-S - TEAM SOLUTIONS, INC.

Connection to digital boards, intended for higher currents. to be used with CPCI-1500, APCI-1500, APCI-1564, APCI-2032.

Product

Portable Three-Phase Energy Standard

PEWM-3C

-

EMSYST Ltd

PEWM-3C - EMSYST Ltd

The three-phase energy standard PEWM-3C is used for quick on-site tests of all types of electricity meters – for active, reactive or apparent energy, two-, three- or four-wire connection. Three voltages and three currents are measured at the same time. The current can be measured either via direct connection up to 10A (class 0.1), or with three current clamps (CC) to 120A, 150A or 1000A (class 0.2).

Product

Frequency Conversion Rotating Magnetic Fla

MT-2XCF

-

Mitech Co., LTD.

MT-2XCF - Mitech Co., LTD.

MITECH MT-2XCF rechargeable frequency conversion rotating magnetic flaw detector is based on principle that the leakage magnetic field can absorb the magnetic powder. Make use of magnetic yoke magnetized the workpiece of ferromagnetic material. If there has defects it will produce leakage magnetic field that will adsorb magnetic powder. We could detect the flaw by observing the density of adsorption magnetic powder. It adopts large capacity lithium battery. By the inverter and the phase shifted signal processor to provide power for the detector, it solves the shortcomings of traditional magnetic particle detector relying on the 220V power supply. It has low power consumption and can continuous work for more than 6 hours. And the battery can be charged when the detector is on and off. Especially suitable for the field testing. It can choose the current frequency according to the flaw depth with unique frequency conversion communication design, that improve the detection sensitivity. It’s widely used in aircraft manufacturing, boiler and pressure vessels and other fields. It is a necessary professional precision instrument of quality control, in-service safety monitoring and life assessment.