PON Power Meters
-
-
Product
DC Power Supply, 35 V, 1 A, 35 W
E36104B
DC Power Supply
The Keysight E36104B is an accurate, 35 V, 1 A, 35 W compact power supply for your bench or system.
-
Product
Battery Impedance Meter
-
Operation is fast and simple. Just press the spring-loaded probes onto the two poles of the battery. After 1.5 seconds, the unit beeps (indicating good contact) and displays the battery voltage and either the number of siemens or milliohms, depending on the knob setting. The display continues to show these numbers after the probes are removed; it resets only when the probes are pressed onto the next battery. The impedance and voltage of any battery between 1.2 and 60 volts can be read. Because of the wide range of voltages, even single low-voltage cells, such as NiMH, can be measured. The manufacturers of some batteries specify impedance in milliohms while other specify in siemens (one divided by the resistance in ohms). This meter will display both types of impedance for any given battery. Accuracy is +/- 2% of the value.
-
Product
Micro Power Contacts
-
Rated to 10,000 cycles.Rated to 21 Amps cont w/ 12 AWG wire.Max contact resistance of 1.5 mOhms.Mating force of 2 lbs.
-
Product
Voltage Meter
MN8I
-
The МН8И mezzanine module (mezzanine) is designed to measure instantaneous voltage values over eight differential channels isolated from each other.
-
Product
Linear Power Supply
-
Toellner Electronic Instrumente GmbH
Can only step down an input voltage to produce a lower output voltage.
-
Product
Dew Point Meter
HT-6292
-
Dew Point meterMODEL: HT-6292 MEASUREMENT RANGE:TEMP.:-10~60?HUMIDITY:10~95%RHDEW POINT:-60~60?
-
-
Product
Miliohm Meters
-
Measures low resistance to detect faulty connections that degrade electrical system performance.Prevent electronic failures.
-
Product
Contact Resistance Meter
CRM 200B+
-
CRM directly measures micro-ohm values at 200A DC under live EHV switchyard conditions quickly & accurately. It is specially designed to reliably measure micro-ohm contact resistances of Circuit Breakers, Isolators, Busbar joints, earth switch joints, welded joints etc., under the hostile electrostatic noise found in live EHV switchyards up-to 765 kV. SCOPE’s ability to make electronics work in such environment enables CRM to measure mili-volts signal in the presence of kilo-volts noise.
-
Product
Power Networks Test
TX6000
-
The TX6000 is a hand held Time Domain Reflectometer with 11 range scales covering the range 0-6000 meters, with a 7 mater first range scale and a 0.5 meter dead zone near and far end faults are clearly displayed on its 128×64 pixel back light Liquid Crystal Display.
-
Product
Power Supply, 150 V, 34 A, 5100 W
N8760A
Power Supply
The Keysight N8760A power supply is a single output power supply in a small 2U package that offers essential features to fit your budget. The N8760A power supply offers flexible AC input options, analog / resistance control of output voltage and current, as well as parallel and series connection of multiple supplies to achieve more output current or voltage.
-
Product
FTTx PON Deployment Made EASY
-
Streaming 4K video, online gaming, work-from-home initiatives, richer internet content and more are fueling a global demand for higher bandwidth FTTx PON deployments. When it comes to test and inspection of these networks, there are many challenges unique to each PON application.
-
Product
Meteorology (WBGT Meter)
-
A WBGT device is a measurement tool that uses ambient temperature, relative humidity, wind, and solar radiation from the sun to get a measure that can be used to monitor environmental conditions during exercise.
-
Product
Power Management
-
Menlo’s family of custom power management ASICs are designed to make the Ideal Switch even easier to use, opening up new applications and markets.
-
Product
EC/TDS Nutrient Meter
EC40
-
The Milwaukee EC/TDS Nutrient Meter is designed for Hydroponics, horticulture and agriculture to help you make sure that your vegetables and plants are receiving the right amount of nutrient to promote healthy growth with low to zero product waste. Keep EC/TDS in your target range to help your achieve better results.
-
-
Product
Power and Energy Meters
-
ENTES Power and Energy Meters are designed to measure the active, reactive and apparent power values and active and reactive energy values of a network.
-
Product
Digital Pressure Meter
ZET 7012-A-VER.1
-
Digital pressure meter ZET 7012-A in BP4-1 casing is used for fast and simple absolute pressure measurements and measured values data transfer in digital format via RS-485 or 4-20 mA interface.
-
Product
Pocket Vibration Meters
DVM-0500/0600
-
Phase II now brings the latest state-of-the-art pocket vibration meters into our ever expanding product line of testing instrumentation.The DVM-0500/600 pocket vibration meters utilize the singular velocity parameter, making testing easy. A full frequency range is available for broad detection abilities.
-
Product
Field Strength Meter
FIM-71 VHF
-
The Model FIM-71 is a portable, laboratory quality Field Strength Meter designed for rigorous field applications. Combining a calibrated half-wave dipole antenna and a highly accurate tuned voltmeter with a range of 140 dB, the FIM-71 is suitable for practically all types of RF emission measurements in the 45 MHz to 225 MHz spectrum. The operator can switch select wide or narrow bandwidth, peak or average value of TV or pulse modulated signals, AM or FM demodulation, and a meter dynamic range of either 20 dB or 60 dB. A dc analog output voltage, proportional to the meter indication, is provided for driving a chart recorder. A leveled output from the calibrating oscillator is available for measuring cable insertion loss, filter response, amplifier gain, and other signal ratio measurements. The 4-1/2 inch, taut band, mirrored scale meter is calibrated in volts and dB for precise measurements in field or laboratory environments.
-
Product
80W Triple Output Power Supply, 6V, 5A & 25V, 1A
E36311A
Power Supply
The 80-Watt E36311A is a clean reliable bench power supply for general purpose applications. It combines convenient benchtop capabilities with flexible system features in a compact intuitive package. This is the most basic of the three models in this product family. For more advance capabilities such as data logging, output sequencing, list mode and auto parallel/serial explore the E36312A (80 W) and the E36313A (160 W) models.
-
Product
DC Power Supplies
-
Is the unidirectional flow or movement of electric charge carriers (which are usually electrons). The intensity of the current can vary with time, but the general direction of movement stays the same at all times. As an adjective, the term DC is used in reference to voltage whose polarity never reverses.
-
Product
Advanced Metering Analytics
BEACON®
-
The BEACON Advanced Metering Analytics (AMA) mobile solution from Badger Meter is built on a century of water metering experience. Combined with our intuitive BEACON AMA software suite, and proven ORION communication technology, the BEACON Advanced Metering Analytics (AMA) mobile solution prepares you for the future.
-
Product
Dynamic Gravity Meter
TAGS-7
-
TAGS-7 represents the latest development in a long line of LaCoste-based airborne gravity systems, stretching back to the first successful airborne gravity flights in 1958 and building on the success of the TAGS System.
-
Product
4-Way Power Splitter/Combiner
ZN4PD1-183W+
-
Mini-Circuits’ ZN4PD1-183W+ is a 4-way 0˚ splitter/combiner covering a wide range of applications from 4000 to 18000 MHz including test and measurement, EW, SatCom and more. This model is capable of handling up to 30W RF input power as a splitter and passing up to 4A DC current from the sum port to alloutput ports (100mA each port). Its outstanding combination of high power and low loss minimize intrinsic losses and provide excellent signal fidelity from input to output. It also provides high port-to-port isolation, excellent VSWR and low amplitude and phase unbalance. It comes housed in a rugged aluminum alloy case with SMA connectors at all ports.
-
Product
Clamp Meters
-
Sanwa Electric Instrument Co., Ltd
An electrical tester that combines a basic digital multimeter with a current sensor. Clamps measure current. Probes measure voltage.
-
Product
pH Ion Meter
-
pH Ion Meters can be used in research institutions, and at a variety water quality related production sites in the mining, agriculture, forestry and fishery industries, for measuring the ionic concentration and various laboratories for the researches and drug manufacture processes. In addition, it is used in agriculture to measure the salinity levels of surface water and of soil samples and also measure the quality of water.
-
Product
DC Power Supplies
-
Scientech Technologies Pvt. Ltd.
Power Supply is the most indispensable component of any electronic laboratory. A reliable, most accurate, fully specified, guaranteed and an efficient Power Supply Equipment are thus manufactured on a large scale by Scientech Technologies which has robust output protection and fault detection capabilities. DC Power Supplies with Different specifications of Voltage and Current are being manufactured for various Applications. The DC power supply converts the conventional 110 V or 220 V alternating voltage into continuous pulsating DC voltage (+3.3 V, +5 V, +12 V and -12V) used by various electronic components. A DC Power Supply also regulates the voltage to eliminate spikes and surges common in most electrical systems.
-
Product
Power Operational Amplifiers
-
ST offers a portfolio of power op-amps characterized for high output current, low drop and high gain. This makes them suitable for a wide range of applications and, in particular, for driving inductive loads such as motors and lamps, as well as in automotive applications offering superior performances. Our op-amps are available in insertion and surface-mount packages to meet different environmental requirements.
