Locators
are used to find or position.
-
Product
Location-Aware IoT Sensors
swarm bee Family
-
Location-Aware IoT sensors target the growing market for autonomous smart devices and cuts time to market for location-aware IoT products by 12 months. Very precise low-cost location and sensor technology can now be used without the need for RF-design capabilities or experience on low level drivers. swarm bee modules have a compact footprint providing a convenient form factor for customized tag designs. An antenna, a battery and housing are the only necessary external components to rapidly construct low power tags.
-
Product
Electronic Stethoscopes
-
Electronic Stethoscope Standard Headphones are designed to help locate the source of excess bearing and machine noise easily at low cost, it is an ideal easy to use listening device for mechanically generated noise in all types of applications, the 3.5mm jack socket tape output can also be fed into an audio tape recorder to store the data for either further analysis or as a reference for future comparison.
-
Product
Occlusal Analysis with BiteForce DynamicsTM
T-Scan
-
The T-Scan is a diagnostic device that measures relative biting forces, including occlusal force, timing and location and is an ideal complementor to articulating paper. The technology was invented by Dr. William Maness in 1987 at Tufts University and M.I.T.
-
Product
Cable Fault Locator
TX4000
-
Auto Fault Location Rugged Palm-Top design Weighs less than 350g (12oz) 11 Measurement Ranges up to 4000m 25, 50, 75 & 100ohm Selectable Cable Impedance User Variable Gain Control Built in Tone Generator for Pair Tracing and Identification Suitable for testing all Communication and Power Cables Environmental Protection IP54 CE Approved Soft bag & Test Leads
-
Product
Above Ground Insulator Tester / RF-IT
RF-IT
-
Hand Held InstrumentEasily locates shorted bolts, replaces bolt to boltUse on structure with or without CPUses Radio Frequency to test effectiveness of above ground insulatorsAuto Shut-Off feature
-
Product
EMI Check & Resonance Analysis Software
EMI Stream
-
At the placement design stage, EMI Stream software examines optimal locations for parts by using actual .dsn files and verifies the effects of the proposed EMI solution. EMI Stream can analyze resonance which occurs between the power and ground planes by analyzing the resonance which occurs and changing the locations of capacitors.
-
Product
Tone And Probe Kit
#TP150
-
Make cable tracing easy with Platinum Tools’ Tone and Probe Set. With its steady tone, push-to-scan button and a clear loudspeaker, quickly trace and identify cable locations on jacks or through walls. Wire bundles are easily penetrated with the tapered probe tip and the probe volume is controlled with a thumbwheel. With common send and […]
-
Product
Global Buoy Monitoring/tracking Beacon With Iridium SBD Telemetry.
Globeacon™ GPS Tracker
-
Strap the Globeacon to a buoy to monitor its location anywhere in the world using the Iridium SBD satellite telemetry system. Real-time status and data available via the web, text messaging, or insert directly into your own application using our API interface.
-
Product
FiberPulse OTDR
XO1
-
FiberPulse OTDRs send pulses down fiber optic networks from one end of the fiber, displaying a trace and reporting all detected events such as splices, connectors, macrobends and fiber ends and breaks. The total fiber length is reported along with name, location, loss and reflectance of detected events. The intuitive keypad design features integrated shortcut keys designed for quickly positioning and analysing events. Another feature of this unit is the Live Optical Signal Detect Function, which tests if the fiber is live before sending the pulse, this can effectively prevent accidental damage to the OTDR and attached communication equipment.
-
Product
Powerful Diagnostic Instrument
Flex-US
-
The design of the Flex.US is based on the popular "Flexible Sensor" from SDT. Mounted on the end of a flexible steel pipe, the ultrasound sensor can access any hard-to-reach location. Bend, twist and curve your Flex.US to suit your inspection. Safely scan electrical cabinets and behind machinery guards without putting your hands in danger. To ensure comfort, the volume control is quickly adjusted when very loud ultrasounds are encountered. This sensitivity provides a high level of precision making leak detection a pleasure, not a chore.
-
Product
Transverse HD Sawmill Meter
MC PRO 1500 HDNC
-
Finna Sensors built the Transverse HDNC Sawmill Meter to increase the number of potential sensors from 8 to 24. The sensors can now be specified to fit within chain runs and can be located on both the top and bottom faces. This significant increase in surface area allows mills to identify sapwood/heartwood boundary areas or wet pockets for proper sorting prior to kiln drying. Sorting by moisture content has been shown to improve drying productivity by 10% to 15%, as well as, enhance lumber recovery. Further advancements in the software allow users to track packages through the drying process, add Internet of Things (IOT) data and perform advanced analytics with new reports.
-
Product
Isolation Tester UIP
-
The devices of the UIP (Union Isolations Prüfer) isolation tester series are used to test the pore-free condition of corrosion protection coatings of pipes, vessels or plant system parts. The battery-powered device generates test voltages between 5 kV and 30 kV, which are applied to the grounded test object via test electrodes. The location of a defect is signalized by a spark-over with an additional audible warning.
-
Product
Mini Bug Detector II
P7050
-
Peace of mind is now within your reach. The Mini Bug Detector™ offers state of the art protection against wireless microphones and transmitters. Perfect for securing homes, offices and hotel rooms, the unit not only detects such devices, its LED display and audio tone actually pinpoint the precise location of bugs. The audio alarm can be turned off for discreet sweeps, while the unit’s sensitivity adjustment minimizes false alarms. The Mini Bug Detector™ features wide range circuitry that enables it to detect concealed transmitters operating on frequencies from 50 MHz to 3 GHz, exposing most high frequency transmitters as well as more common VHF and UHF bugs. You didn’t know they were listening…until now.
-
Product
Cable Fault Locator ECFL 30
ECFL 30
-
Compact precision active/passive, AC/DC bridge with dual channelTDR for fault location on balanced loaded and unloaded cables.
-
Product
Radio Interception & Direction Finding Systems
-
Net Radios are used by many organisations including anti-national elements, and it has always been a cause of concern for the LEAs. Stratign provides solutions for interception, demodulation and decoding of HF/VHF/UHF communications with the capability of finding the actual location of the transmitters.
-
Product
Dual Channel Temperature/Relative Humidity-40 to +85C/0 to100% RH
TGIS-1580
-
This model is battery powered and measures both temperature and humidity using built-in sensors, providing cost effective environmental monitoring ideal for inaccessible locations.
-
Product
550 HP Water Brake Chassis Dynamometer
CM-51S
-
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred.
-
Product
Cable Test Vans and Systems
-
Precise cable fault location, testing of new and diagnostic testing of existing cable routes – the BAUR cable test vans are suitable for any operation. Fast and reliable. Exactly adapted to individual requirements and predefined vehicle systems.
-
Product
Measuring Systems For Beverage Can Manufacture
SPECIAL WORKBENCH
-
Optik Elektronik Gerätetechnik GmbH
To ensure the high measuring accuracy of RINGMASTER and PUNCHMASTER also under rough environmental conditions, a special workbench was developed. The workbench is equipped with vibration isolators, so that the equipment works also stable, if the toolroom is located close to the production line. Based on its ergonomics the special table ensures a fatigue free work.
-
Product
IP and Port Monitoring Software
CallerIP
-
IP and Port monitoring. See all incoming and outgoing connections made to your computer. Including process names, remote and internal port numbers and much more. Automated alerts bring your attention to illegal connections. Automated Alerting. Set up alerts to warn you of intruders and hack attempts. CallerIP can send an email, display a warning dialog and/or append a log file. CallerIP Server. CallerIP server allows you to view all incoming and outgoing connections to your computer from any browser in the world. CallerIP plots all connecting IP locations on a world map. IP origin shown on world map. All connecting IP address locations are shown on a world map.
-
Product
Cable Testers
-
The Tester can check UTP and STP Cat 5E,6,6A and Coaxial Cable. It can ldentify and locate the distance of a open or Short Circuit. With the Multifunction Tester you can determine the Continuity and Wiring of the Cable Pattern. Comes with the Low Battery Indicator. It uses TDR ( Time Domain Reflectometer ) to measure the length and distance of the cable. LCD Backlight Display.There are 8 Remote ID available.
-
Product
Near Field Micro Probes ICR HH H Field
-
The measuring coil is horizontally located in the probe head. The near field micro probes are operated with a positioning system (Langer Scanner).
-
Product
Platinum Tools Fiber Optic Visual Fault Locator
#TVFL100
-
Fiber optic visual fault locator works with virtually all 1.25mm and 25mm fiber optic sizes and connector types.
-
Product
Visual Fault Locator ( VFL)
TM315N
-
The TM315N Economical VFL is an efficient and low cost basic fiber test tool, it provides a visible way to find fiber faults and identify fibers in an optical network during and after installation.
-
Product
Surge Voltage Generator
SSG 2100
-
Cable fault location with the BAUR SSG 2100. Surge voltage generators are used for pre-location and pinpointing of high- and low-resistive as well as intermittent faults in power cables. The energy stored in a high-voltage capacitor is released at regular intervals or as DC voltage. The thus generated acoustic signal at the fault position can be recorded with a ground microphone and a universal receiver.* High surge voltage up to 32 kV* Continuously adjustable voltage* Voltage monitoring through kV meters with 3 measuring ranges* Automatic discharge unit
-
Product
Static Meters
-
ETS static meters are offer accurate detection and measurement of static electricity found in the manufacture and handling of electronic, paper, plastic, textile, food, chemical, biomedical, and pharmaceutical products. In addition, these meters are invaluable for use in computer rooms, cleanrooms, hazardous environments, hospitals, and other locations that require the measurement of electrostatic fields. Chopper-stabilized models enable measurements in ionized environments.
-
Product
9025 VXI - 25 Module Solution for VXI
-
The 9025 VXI Receiver is a 25-module solution designed for use with VPC pre-wired interconnect adapters, but can also accommodate a combination of pre-wired interconnect adapters and discrete-wired modules using retainer blocks.1-4 modules attach to an interconnect adapter which in turn is attached to the VXI card. This connector “funnel” forms a complete VXI module, which is easily inserted or removed from the VXI mainframe for maximum flexibility in testing applications. The interconnect adapter also provides room for driver sensors. External cabling to the card is done with a cable clamp or connector located on the top or bottom of the adapter. The positioning of funnels and use of discrete wiring modules can affect the performance of the product. Please contact us for technical assistance.
-
Product
Cylindrical Type Fiber
-
Panasonic Industrial Devices Sales Company of America
Panasonic Cylindrical Type Fibers have a slender shape which can be mounted in narrow locations using screws. The line up includes Ultra-Thin Fibers with Ø0.25mm tips.
-
Product
AUDIO LOCATOR PROBE
45/90
-
Easy to operateUnaffected by surface coverLight weight and strongWater resistant, build for rugged field useTelescoping handleDepth locator "bubble"
-
Product
Car Parks Testing Equipment
-
Leaks in car park waterproofing systems can be located by using our Wet Roof Pro' leak detector kit or one of our dry roof leak detector kits, such as the PD30R or PD40R.
