Optic
-
Product
High-speed Fiber Stretcher
PZ1
-
The PZ1 is the high-speed member of our family of fiber stretchers. It is a fiber wound piezoelectric element for use in a wide range of optical interferometric measurement and sensing system applications. Typical uses include open loop demodulation, sensor simulation, variable optical delay, general purpose fiber interferometry and large angle modulation of interferometric phase.
-
Product
Low Profile PCI 8 Reed Relay Output
8012
-
The 8012 Low Profile PCI digital interface provides eight Reed relay outputs (SPST) and eight optically isolated inputs. Reed relays are well suited for low current applications. The relays are normally open, and close when energized. The board is MD1 Low Profile and Universal Bus (3.3V and 5V) compatible.
-
Product
Optical Power Meter
PM203
-
The PM203 optical power meter can be used to measure the radiometric power in a beam of monochromatic or narrow band light. Using the internal calibration table the micro-processor controlled PM203 displays directly the optical power in Watts or dBm or the calibration wavelength.
-
Product
Residual Pollution Analysis System
Cleanalyzer
-
The Cleanalyzer is a high-end analytical system designed to examine particles on filters – a key procedure in performing reliable and reproducible evaluation of component cleanliness. High-resolution, optical zoom system (15µm and 5 µm version. High-resolution, fixed magnification optical system (35µm version).
-
Product
PCI Daughter Boards
DB-24POR
-
The DB-24POR has 24 channels of optically isolated Photo-Mos Relay , and OPTO-22 compatible connector.
-
Product
Laser Diode Driver
S-101
-
LD Driver slot module of FOTS system is an efficient module that is user centered, which can drive various kinds of laser diode for the use of optical signal transmission or light source. The module has a built in LD socket, in which LD of 14 pin butterfly type is installed, which makes it possible for the user to change the LD he or she wants to drive when needed. It is leaded to get rid of the inefficiency of expense, at which various types of expensive united source module needed are purchased. By operating monitoring PD and high-performance processor that are installed inside the module, the output power and temperature of LD can be driven accurately and stably. The laser diodes can be modulated internally in square, sinusoidal, and triangular waves and its output power and temperature can also be maintained the level set by the user. In order to realize the various functions, the efficient and multi-functioned control programs with high speed processor, LCD monitor or GUI for remote control are available.
-
Product
Random Number Generation
-
Quantis is a family of hardware random number generators (RNG) which exploit elementary quantum optical processes as a source of true randomness (cf. Wikipedia: physical phenomena with quantum random properties). Photons (light particles) are sent, one by one, onto a semi-transparent mirror and detected. The exclusive events (reflection or transmission) are associated to “0” or “1” bit values. Such quantum processes provide instantaneous and inexhaustible entropy.
-
Product
Thickness Gauges
-
Bristol Instruments'' optical thickness gauges are a simple and non-destructive way to precisely measure thickness of a variety of transparent and semi-transparent materials. Thickness information is critical in the development and production of materials such as contact and intraocular lenses, and medical products including balloon catheters, stents, bags, and tubing. Bristol combines high accuracy with straightforward operation and rugged design to make these instruments ideal for both laboratory and manufacturing environments.
-
Product
Turret Integrated Rotating Systems (OMFV)
-
Slip Rings can be fitted on tank turrets and military vehicles for frontline operations, allowing power, Ethernet, video and CAN bus signals to be transmitted on the battlefield using fiber optic channels.
-
Product
Content Verification System
Pulsar
-
Pulsar is an automated content verification system for stored media files. It is designed for use by Broadcasters, Service Providers, Content Creators and Optical Media replicators allowing them to analyze the content before it is put live or stamped on the optical media. The software performs conformance and quality analysis on the streams provided. It allows definition of a range of user-defined checks to be performed as part of the Analysis.
-
Product
Fiber Optic Testers
-
SYOPTEK designs and manufactures fiber optic tester(fiber optic test equipment) for optical fiber cabling installing, maintenance, and verification; provides you quality, reliable fiber optic tester at a affordable price.
-
Product
High-Accuracy Automated Optical Inspection Systems
-
Fully-automated and high-accuracy 3D inspection and measurement systems. High-power, long working distance optics and high-resolution digital camera are perfect for high-magnification applications. These are full-color systems capable of high-accuracy measurements, automated defect detection and color verification.
-
Product
Optical Comparators
-
Starrett optical comparators provide a time tested, cost effective, solution for non-contact measurement. Optical comparators are used for an exceptionally wide range of dimensional inspection applications.
-
Product
Optical Spectrum Analyzer
-
an optical spectrum analyzer for analyzing short wavelengths from 350nm to 1000 nm. Because it adopts a Fourier spectrum system with a Michelson interferometer, the 8341 can measure the coherence. With its narrow wavelength resolution of 0.01nm * , the 8341 is very effective for the evaluation of not only CD/DVD laser diodes, but also for blue-violet laser diodes. In addition, the built-in He-Ne laser acts as a wavelength reference to ensure a high wavelength measurement accuracy of ±0.01nm * . Finally, with its fast 0.5s * measurement speed, the 8341 is ideal for building into systems for mass production and evaluating temperature characteristics of system components.
-
Product
PXI/PXIe MEMS Optical MUX, 4-Channel, Single-Mode, 9/125 Fiber, ST Connectors, With Interlock
42-850A-514-HI
-
The 40/42-850A-514-HI is a PXI/PXIe 4-channel multiplexer with ST connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
Product
Cable Certifiers
LANTEK III Series
-
New permanent link adapter saves money. Send test data anywhere using IDEAL AnyWARE app. Certifies multimode and single-mode fibre (optional). Professional PDF reports with free software. Certifies twisted pair cabling to TIA/ISO standards. The LanTEK III is an easy to use cable certifier that meets existing TIA and ISO/IEC performance requirements for testing up to Cat 7A/1000MHz. FiberTEK III adapters are used with LanTEK III for fast and simple certification of high bandwidth single-mode and multimode fiber optic cabling including support for encircled flux testing.
-
Product
Spectroscopy
-
Spectrometers are used to measure the properties of light for a variety of applications including environmental or chemical analysis, fluorescence, or Raman. Spectrometers are optical instruments that can detect spectral lines and measure their wavelength or intensity. Spectrometers are ideal for determining compositional makeup for detecting weak light signals. Spectrometers can also be used to test the efficiency of an optical filter in order to determine whether a filter has properly blocked or transmitted specific wavelengths.
-
Product
LED/CCD Optical Micrometer
LS-7000 Series
-
Breakthrough technology intelligent optical micrometer with 0.01-micron high resolution, 2400 samples/second high speed. Maintenance - free LED emitter and design (no laser diode or motor). High performance controller with statistical analysis. Controller with target viewer available for easy setup
-
Product
Second-Grade Service Area Externally Modulated Optical Transmitter
HT8500A
-
Hangzhou Huatai Optic Tech. Co., Ltd.
How to select 1550nm optical transmitter for second-grade service area is always a difficulty. Take technical feature and long-term development of the network into consideration, we should select 1550nm Externally Modulated optical transmitter, however, such transmitter with reasonable price which can be suitable for Second-grade service area is unavailable in the current market. Considering the traditional cost, 1550nm Internal Modulated optical transmitter will be selected to have a test.
-
Product
Electrochemical Cells
-
PotentioLab supplies electrochemical cells for controlled three-electrode experiments, photocatalysis, corrosion testing, sensing and teaching laboratories. Choose from glass cells, PTFE cells, H-type divided cells, optical cells with quartz windows and custom sealed electrochemical cell assemblies for research workflows.
-
Product
Next Generation Network Testing
UX400
-
The VeEX UX400 is the smallest multi-service transport test solution to offer test capabilities ranging from DS1/E1 all the way up to 6x 100G traffic generation, supporting the latest 100G/40G optical pluggable form factors (CFP4, CFP2, CFP, QSFP28, QSFP+, no adapters required). Its modular architecture allows for up to six independent test modules and up to twelve concurrent tests or combinations of tests, including legacy PDH/DSn, SDH/SONET, OTN, Ethernet, Fibre Channel, CPRI/OBSAI, C/DWDM spectrum analysis and more. The platform's software architecture has been developed so that multiple users or scripts are able to access and operate different test modules at the same time, maximizing the use of resources. A battery backup option is available for the portable UX400 platform. Test modules can also operate in a standard 19" rack – the UX400R, when portability or battery operation is not needed.
-
Product
One-Piece Optical Sensor Head
OP
-
Sciences et Techniques Industrielles de la Lumière
OP series consists of a one-piece optical sensor head for dedicated applications (e.g. long distance).The performance and specifications are dedicated to various applications in the industry.Typically integrated as OEM for measuring 3D shapes, glass thickness, autofocus, OP series fits a wide range of applications.
-
Product
Fiber Identifier & VFL
-
Are designed to non-invasively identify continuous-wave signals in fiber optic cables. They are low cost, hand-held tools.
-
Product
Color Sensor
AF16-F
-
High precision sensor for direct installation into pipelines measuring VIS or NIR light absorption of various liquid samples. Wavelength and optical path length can individually configured to meet the process control requirements with the highest accuracy.
-
Product
Fiber Bragg Grating And Optical Filters
-
Exail is committed to develop and manufacture optical components with excellent performances to support the most diverse industrial applications such as Telecom, sensing, defense, space, fiber laser and harsh environment.
-
Product
Space Grade Components
-
Exail stands as a leading designer and manufacturer of space-grade optical components, meticulously crafted for challenging space environments. With a proven track record in successful missions, our "flight proven" components exhibit unparalleled robustness and reliability, even under extreme conditions.
-
Product
Optical Power Meter
-
Shaanxi Aitelong Technology Co., Ltd
Is a device used to measure the power in an optical signal.
-
Product
PXIe HSS Optical FPGA Board
PXIe-8324
-
The Conduant PXIe-8324 Optical FPGA board provides the user with a hardware platform that is able to sustain full-duplex high-bandwidth transfers through its 8-lane Gen3 PXI Express (PXIe) interface and its 24-lane optical interface.
-
Product
DPSS Lasers
-
We honour ourselves in providing the broadest range of high-performance Diode-Pumped Solid-State Lasers (DPSSL), or as Cobolt have embraced: Diode-Pumped Lasers (DPL). The laser cavities include frequency-selective optics which stabilize the resonator and prevent all but one longitudinal and transversal mode of the laser to be amplified in the oscillator, which results in extremely stable single-frequency (SF) or single longitudinal mode (SLM) emission and a perfect diffraction limited beam.
-
Product
IEC61850 Digital Substation Testing
-
With the development of power system, more and more digital substation based on IEC61850 has been built in the world. IEC61850 is the new communication protocol which is adopted by power system so as to change the analog complicated wiring connection and protocol conversion. Based on IEC61850, all Messages, such as GOOSE, SV, MMS, PTP, etc, could be communicated on the Ethernet via fiber optical cable connection. In China, the digital substation have started since 2003, until now there are already more than 6000 digital substation put on operation, China Power Grid is planning to build 5000 more new digital substations. PONOVO, as the leading power system testing solution provider, have launched plenty of IEC61850 digital testing tools, not only digital relay test set, but also MU test set, multi-functional analyzer, 24 hours online monitoring and analyzing system, etc so that users could have suitable testing equipment for the digital substation commissioning and testings.
