Product

Automatic Battery Monitor

BA24-2020

-

dfv Technologie

BA24-2020 - dfv Technologie

The BA24-2020 automatic battery tester makes it easy and efficient to test each cell of a battery. It makes it possible to receive a new battery and to revalidate it regularly.

Product

TDRSS

-

L-3 Cincinnati Electronics

L-3 Cincinnati Electronics

L3 Cincinnati Electronics (L3 CE) continues to broaden its offering of TDRSS-compatible receivers and transmitters. Virtually any TDRSS forward or return service can be utilized with the following products. All TDRSS products have been live-link tested with the TDRSS constellation to insure compatibility.

Product

Frequency Demultiplexer

-

Becker Nachrichtentechnik GmbH

Becker Nachrichtentechnik GmbH

Modern receivers for broadcast have a large number of antenna inputs for the different radio bands. The devices of the FDMX series can be used to supply the antenna inputs with RF signals. The devices of the FDMX series splits a sum signal in frequency division multiplex into the individual broadcast bands and the L1 satellite navigation band (GNSS). Additionally, DC loads are provided for each antenna input to simulate active antennas. The presence of remote power supply is indicated by an LED on the units.

Product

Spectrum Analysis

S95090B

-

Keysight Technologies

S95090B - Keysight Technologies

The S95090B spectrum analyzer (SA) measurement software adds high-performance microwave spectrum analysis to PXI VNAs. With fast stepped-FFT sweeps resulting from optimized data processing, the SA software application provides quick spurious searches over broad frequency ranges. The S95090B software uses the PXI network analyzer's test and reference receivers to complete simultaneous spectrum measurements. Multi-channel SA measurements leverage the PXI VNA's internal swept-signal generators for efficient measurements of spurious signals emanating from mixers and frequency converters. The S95090B spectrum analyzer software application employs source-power and receiver-response calibration as well as fixture de-embedding, providing in-fixture and on-wafer spectrum measurements with the highest level of accuracy. Optional external attenuators should be connected with the VNA’s test ports to avoid receiver compression when measuring large signals.

Product

Quartz Sensor Fiber Head

SLG-1001

-

SAN-EI ELECTRIC CO.,LTD.

SLG-1001 - SAN-EI ELECTRIC CO.,LTD.

Pure quartz fiber stands aving high UV transmission properties are used. This is the quartz sensor fiber head exclusive for the UV MONITOR SERIES excelling in flexibility and durability. The exclusive use receptacle for the light receiving inlet is also available.

Product

1208/9a Optical Distribution, RX/TX

-

Precise Time and Frequency, Inc.

Precise Time and Frequency, Inc.

The ptf 1208A (transmitter) and ptf 1209A (receiver) provide a convenient and simple way to transmit high quality RF signals over long distances, without the concerns associated with electrical interference and pick-up.The ptf 1208A accepts an RF input in the range from 1kHz up to greater than 10MHz and provides a combination of 8 local, high isolation, RF distribution outputs and 4 optical transmission outputs for distances up to 2 kilometers.The ptf 1209A accepts an optical input (transmitted from the ptf 1208A) and provides 12 local RF outputs, either digital (TTL into 50 ohms) or low noise sine wave signals driving 1V rms into 50 ohms (with the PLL option), or both.These systems are especially designed to accommodate IRIG B DCLS, 1PPS and other RF signals in the range from 1kHz to 20MHz.The modular construction allows for a variety of input/output configurations to provide a fully tailored application solution.

Product

TVM Cybercast System

2000ST

-

En Technology

2000ST - En Technology

This portable data receiver decodes all standard VBI data formats plus the super robust EnXpress format at data rates from 4800 Baud to 115,200 Baud. The TVModem is rack mountable or stand-alone and features a compact, rugged enclosure for portable environments.

Product

EMC Test Equipment

TDEMI Mobile+ series

-

Gauss Instruments

TDEMI Mobile+ series - Gauss Instruments

The new benchmark for your fastest product pre-certifications on the planet. The new TDEMI Mobile+ (TDEMI M+) receiver series of GAUSS INSTRUMENTS is a very compact and robust designed instrument for optimum mobility and outdoor use as well as on developers workbench in your lab. It provides a vast variety of functionalities. The TDEMI M+ receiver series is equipped with a +12V supply - so it can be easily used for on-board testing, e. g. in vehicles or aircrafts and so on. By its integrated touch-sensitive and high resolution screen and the embedded PC the TDEMI M+ is a fully stand-alone instrument independent from any control or host or display unit e. g. as a PC or laptop. Thus it provides even more flexibility for your emission measurements. Furthermore the instrument can be powered by a battery pack (Option BAT-UG) making it even more flexible and easy to carry it around without any need of an external power supply. Especially designed for your todays challenging pre-certification tasks the TDEMI M+ provides the absolutely unrivaled advantages in speed and performance of the well known and market approved GAUSS INSTRUMENTS time-domain and RF technology. Thus, your pre-certification measurements and investigations can be performed up to 16000 times faster than by conventional receivers. The instruments of the TDEMI M+ receiver series are available for the frequency ranges up to 1 GHz, 3 GHz, 6 GHz or 7 GHz starting from 9 kHz each. Additionally these blazing fast measurements can be carried out even starting from 10 Hz optionally (Option MIL/DO-UG).

Product

RX Pre-Amplifier System

RAM-34

-

Array Solutions

RAM-34 - Array Solutions

The RAM-34 is a complete pre-amplifier system designed primarily for the low bands 160M thru 40M. It has inputs for four receive antennas and internal 3-pole bandpass filters for 160M, 80M and 40M. In addition to the pre-amplifier, it has a step attenuator that togetherwith the amplifier stage provides gains from -20 dB to +20 dB in 5 dB steps. This allows equalizing the signal levels between the antenna inputs. Gain settings are memorized for each antenna on each band. Different types of receive antennas have different signal levels and the gain memories eliminate the need to adjust the receiver or pre-amplifier when switching between the antennas.

Product

Portable Receivers

SRc & SRc5P

-

Lectrosonics, Inc.

SRc & SRc5P - Lectrosonics, Inc.

The SRc5P and SRc consists of two separate receivers built into a single, ultra compact housing with adapters for video camera receiver slots and for stand-alone use. Digital Hybrid Wireless® technology provides superb, compandor-free audio quality and compatibility with other wireless systems. The RF performance is extremely stable over a very wide temperature range, making the receiver perfectly suited to the rough environmental conditions found in field production.

Product

Mixer

-

Chengdu KeyLink Microwave Technology Co., Ltd.

Chengdu KeyLink Microwave Technology Co., Ltd.

The series of products are passive devices, which are the key units of microwave and RF up-conversion and down-conversion circuits.The products can be applied to all kinds of receiving and transmitting channels. KeyLink's mixers can be categorized as follows.

Product

ICs For Wireless Charging System

-

Renesas Electronics Corp.

Renesas Electronics Corp.

The feature of power receiving and charge/discharge system IC RAA457100 is integrated all functions needed for a wireless chargeing,  rectification, charging control for small Lithium-Ion battery and top level of power-efficiency DC-DC converter in a singl chip as 3.22mm x 2.77mm small package.

Product

Antenna, Active Loop

EM-6869 | 9 KHz – 50 MHz

-

Electro-Metrics Corp.

EM-6869 | 9 KHz – 50 MHz - Electro-Metrics Corp.

The Electro-Metrics EM-6869 Active Loop Antenna is used with any receiver or spectrum analyzer with 50 ohm input and covers the frequency range of 9 kHz to 50 MHz.

Product

Interface Converter

ZET 7076

-

ZETLAB Company

ZET 7076 - ZETLAB Company

Previously it was widely thought that it is enough to receive sensor readings and to have remote control over them. But gradually there evolved a need for remote control, i.e. people need to receive sensors readings and to control their performance via Internet (for instance, on a portable device). Such possibility simplifies quite a lot of tasks since one can control performance of a system located at the other end of the city or even a country.

Product

Pipeline & Cable Locator

STC-PCL 1101

-

Shanghai Stone Communication tech Co., Ltd

STC-PCL 1101 - Shanghai Stone Communication tech Co., Ltd

STC-PCL1101 Pipeline & Cable Locator consists of a Transmitter and a Receiver, used in the underground utilities route locating, the depth measuring and long distance tracing. We adopted multicoil electromagnetism technology on this Pipeline & Cable Locator, enhanced the pipeline localization to decide the depth precision and the goal pipeline recognition capability, also could accurately carry on tracing and the localization in the pipeline crowded complex region to the goal pipeline. Thus it is widely used in the telecommunication, electric, tap water, natural gas, physical prospecting, town planning and so on.. STC-PCL1101 has many optional accessories, thus increased their use, and expanded their application scope.

Product

FTTH Optical Node

SR2020AW

-

Hangzhou Softel Optic Co., Ltd.

SR2020AW - Hangzhou Softel Optic Co., Ltd.

SR2020AW, the operating bandwidth of 47~1000MHz, is a low power, high performance, cost-effective triple play, FTTH CATV optical receiver, Whether used in analog television or digital television. Products with high sensitivity optical receiver tube and  special low noise matching circuit. Receiving at high optical power can be adjusted by PAD level, played limiting output, so SR2020AW within a large dynamic range of the received optical power of +2 dBm ~-21dBm, have excellent characteristics.

Product

Test Receiver

FSWT

-

Rohde & Schwarz GmbH & Co. KG

FSWT - Rohde & Schwarz GmbH & Co. KG

The R&S®FSWT is the right tool for detecting compromising emanations. With two equivalent, switchable RF inputs, up to 500 MHz measurement and analysis bandwidth and two analog outputs for video voltage and demodulators, the R&S®FSWT fits perfectly into typical test setups and easily replaces older instruments.

Product

GPS Master Clock

-

Signals & Systems India Private Limited

Signals & Systems India Private Limited

GPS Master Clock System – MCS-GPSMC-1010 is a 3U Card rack type, 19” Rack-mountable Redundant GPS Time Server which synchronizes and maintains the timing and frequency requirement of power and process industry equipment using a signal obtained from any one of the sources like GPS or GLONASS or Time protocols such as NTP and IRIG. It distributing the same time signal through several types of interfaces. It provides redundancy for Power and GPS receiver to increase reliability and offers protection against time synchronization failure. The system is field-upgradeable and an extremely flexible system, designed to handle time synchronization requirements today and in the future. It provides nanosecond accuracy when external time references are not available. It has a storage facility to store the system log file. It delivers NTP, SNTP, IRIG-B, PFC-Pulse, DCF77, BCD parallel data, Ethernet Fiber Optic & RS485/RS232 outputs. System enables configuration and monitoring through Web-based application. It supports a wide range of power supply either 90V-260V AC/DC or 18-36VDC or 36V-72VDC. Power supply model can be mixed and matched as required by the user, depending upon power supply options available at the installation site.

Product

Boundary Scan Compliance Tester

QT900

-

Qmax Test Technologies Pvt. Ltd.

QT900 - Qmax Test Technologies Pvt. Ltd.

QT900 Qscan Test system is designed to provide test solution for both Boundary Scan compliance devices and Non Boundary Scan devices. The System provided with Digital IO’s capable of driving and receiving via JTAG IEEE 1149 standard interface and synchronous to JTAG pins. Both Digital and JTAG test are carried out synchronously. Use of virtual test pin and Edge connector eliminates the need of expensive test fixture strategy.

Product

EMC Accessories

-

Rohde & Schwarz GmbH & Co. KG

Rohde & Schwarz GmbH & Co. KG

Complete your EMC test setup with the essential accessories to compliment the test equipment. Whether it is a LISN (or V-Network) to counteract interference from external power sources on conducted emissions from the device under test, probes to locate the near field sources of radiated emissions, receive and transmit antennas, or tripods for holding antennas in place, the Rohde & Schwarz catalog of EMC accessories provides the additional items you need for EMI and EMS measurements, guaranteed 100% suitable for use with Rohde & Schwarz EMC test equipment.

Product

Digital Camera Hop Transmitter

DCHT

-

Lectrosonics, Inc.

DCHT - Lectrosonics, Inc.

The DCHT portable digital stereo transmitter is designed for use in film and TV production as both a wireless audio link from a bag or cart system to cameras and as a portable IFB transmitter paired with the Duet digital wireless M2R receiver packs. The DCHT accepts two channels of mic or line level analog signals or an AES digital signal from a mixer and transmits to the receiver or receivers in a purely digital format. The digital architecture of the new DCHT is a third-generation design with specially developed, high-efficiency circuitry for extended operating time on two AA batteries.

Product

Hook Ammeters

-

Uni-Trend Group Limited

Uni-Trend Group Limited

Designed with a hook detector, wireless receiver, and telescopic insulating rod. With telescopic insulating rods connected, it can test leakage current, current, frequency, load, and others for bare conductors, bus bars, or cables with safety insulation sheaths.