Soil
earths pedosphere.
See Also: Soil Moisture, Soil Resistivity, Conductivity Meters, Farm, Permeability, Ground
-
Product
Soil Analysis
-
We offer a full spectrum of analytical technologies, and sample clean up and moisture extraction reagents, designed to provide reliable, accurate, and precise results that make compliance easier and help you reduce regulatory risks. Organic Elemental Analysis, Trace Elemental Analysis, X-Ray Fluorescence (XRF) Spectrometry, Automated Discrete Photometry, Gas Chromatography Mass Spectrometry (GC-MS), Accelerated Solvent Extraction (ASE).
-
Product
Soil Moisture, Temperature, and EC Sensors
-
Soil volumetric water content probes (sometimes referred to as soil moisture sensors) measure the water content of soil. These probes can be used to estimate the amount of stored water in a profile or how much irrigation is required to reach a desired amount of water in the soil. These probes can be used for quick measurements or installed for long-term measurements.
-
Product
Optical Identification
-
Application areas of the 1D/2D code reader range from product tracking and product control to product identification.The sensor can read 1D and 2D codes regardless of their position. Even if up to 25% of the code information becomes damaged or soiled, it is still read correctly. The reader can also be used for optical character recognition (OCR), e.g. in order to identify products based on type labels or serial numbers.
-
Product
Outdoor Exposure Tester
OET
-
A comprehensive analysis of PV modules includes many different parameters. Determining the normal module operating temperature (NMOT), incidence angle effects and comparing soiling effects on different modules up to the initial degradation of PV modules are all parameters that can be analyzed with our outdoor exposure tester. The tester comes with up to twelve electronic loads installed in a 19" rack. The loads have two main functions: maximum power point tracking (MPPT) and IV curve tracing. For the advanced analysis, it is possible to change between these two modes within one test. In the normal operation mode, the electronic load keeps the module under MPP and each predefined interval an IV curve is traced. The entire tester comes with all necessary sensors such as temperature sensor, which can be attached to the module to determine the NMOT temperature like defined in IEC 61215 (MQT 05) and IEC 61853-2. The irradiation sensor is also included. In combination with our tracking system P2, it is also possible to determine incident angle effects of the PV module. It is also possible to connect other irradiation sensors for diffuse and direct irradiation, which helps to understand the behavior of the module in different irradiation conditions. An optional albedo meter is a powerful tool for the analysis of bifacial modules. The entire graphical user interface is web based and offers the possibility to access the system from the all computers in the network.
-
Product
Single Position Automated Electric Fluxer
-
Single-position fully automated electric fusion machine with a typical sample throughput of 5-7 samples per hour. Ideal for preparing fused beads for XRF analysis and solutions for AA, ICP, and wet chemistry analysis. Patent PendingTypical samples include: Cement, Clinker, Ores, Slag, Refractories, Ceramics, Catalysts, Glass, Rocks, Minerals, Soils
-
Product
Telurometer
AMRU 120
-
Technical method with 3 or 4 poles, Technical method with the use of additional clamps, Measurement of the continuity of compensating and protective connections with self-neutralization function, Double clamp method without the need to place auxiliary electrodes, Soil resistivity in addition to
-
Product
Leak Tester
AD-1690
-
Are you sure your pipettes are all accurate? Most pipette failures happen due to soiled or damaged parts compromising the airtightness of the pipettes. With the AD-1690 leak tester, you can instantly spot the pipettes that need to be fixed.
-
Product
Spectrometer
AirSPEC
-
Baltic Scientific Instruments, Ltd
Scintillation gamma-ray spectrometer AirSPEC is intended for measuring scintillation spectra and alsofor determination of activities and specific activities of radionuclides in samples and in conditions of natural occurrence in geometries 2 and 4.Spectrometercan be usedfor various tasksradiation monitoring, including the definition ofspecific effective activity of naturally occurring radionuclides (NORM) in building materials (granite,crushed stone, gravel, etc.), raw materials, products, waste industrial productionand rockswithoutsampling; measurements surface activity of the radionuclide 137Cs (and other); mass fraction of NORM in rocks andoresin the conditions oftheirnatural occurrence on a surface, inboreholes and in warehouses andtransportcontainers, and also in study ofsurface contaminationof soil,as well asprospecting and exploration ofmineral deposits resources.The spectrometercan be used forworkin the laboratoryand in the field conditions.
-
Product
Field thermal needle system for thermal resistivity / conductivity measurement
FTN01
-
Hukseflux Thermal Sensors B.V.
The FTN01 Field Thermal Needle System allows performing fast, on-site measurements of the thermal resistivity or conductivity of soils, in particular around the typical depth of burial of high voltage cables. FTN01 is designed with a focus on robustness and saving time, while still offering sufficient accuracy for typical field measurements. The sensor is a Non-Steady-State Probe (NSSP), TP09, which is mounted at the tip of the Lance LN01. The system is operated using a hand-held Control and Readout Unit CRU01.
-
Product
Measuring Earth Resistance
OSP-510
-
Additional equipment to measure the earth resistance and soil resistivity AD-510.
-
Product
LandMapper ERM-03
-
Landmapper is an excellent tool for soil mapping required for environmental consulting, golf courses maintenance, construction services, farm management, new land development, and real-estate planning. It is a must have tool for forensic and archaeological investigators, even for serious treasure hunters. Using this non invasive device prior to soil sampling you can significantly reduce the amount of samples required and precisely design a sampling plan based on the site spatial variability.
-
Product
Field Management
-
EAG offers field-to-final report project management for studies to demonstrate human and environmental safety. As on-site study directors, our Field Managers bring decades of study design, protocol development, analytical oversight, and GLP/QA compliance expertise across a variety of field management study types. In addition, EAG’s access to a broad network of field sites across the United States and Canada ensures that we can deliver the test system, soil characteristics and geography necessary for just about any regulatory need.
-
Product
Soil Mechanics
LIQUITER
-
The LIQUITER program determines the safety factors pertaining to the liquefaction of incoherent saturated terrains subjected to earthquake phenomena.
-
Product
Ultra sensitive heat flux plate
HFP03
-
Hukseflux Thermal Sensors B.V.
HFP03 is an ultra sensitive sensor for heatflux measurement of small heat fluxes through soil, walls and building envelopes. By using a ceramics-plastic composite body the total thermal resistance is kept small.
-
Product
Automated Soxhlet Extractor
Soxtec™ 8000
-
The Soxtec 8000 extraction unit is a fully automated system for fast and safe extraction of soluble matter from a wide range of matrices. It performs the four extraction steps boiling, rinsing, solvent recovery and auto-shut down, fully unattended. Just load, start and walk away. The Soxtec 8000 is specially designed to ensure the highest possible throughput and safety.Parameters: Crude fat, Total fat and Extractable matterSample types: Fat in food and feed. Extractable matter in textile, paper pulp, plastics, rubber etc. PCB and PAH in soil and sludge (the Soxtec is a preparatory step to GC-MS).
-
Product
Moisture Meter
-
An instrument for determining the percentage of moisture in a material (as timber, flour, soil, or tobacco) commonly by measuring its electrical resistivity.
-
Product
Static Soil Tester
GEO-probe
-
The complex is implemented on the basis of a portable computer and the CompactRIO control and measuring system. The software for recording and displaying measured signals and control of measuring equipment is developed on LabVIEW. The second modification of the measuring system includes, developed by our company, a miniature digital measuring module of a strain gage with a built-in ADC and inclinometer and a USB interface for connecting the digital measuring module of the probe to the computer.
-
Product
Environmental Test Equipment
-
Shenzhen Everbest Machinery Industry Co.,Ltd.
Environmental Test Equipment Environmental testing can identify and quantify compounds and pollutants in air, water, or soil.
-
Product
Carbon / Water Analyzer
CW‑800
-
Determination of released carbon dioxide and water is a special requirement for quality control in the cement and lime industry. ELTRA’s CW-800 analyzer is designed for the precise, simultaneous determination of carbon dioxide and water in lime, gypsum and cement from trace level up to 100 % (depending on sample weight). Other sample materials include ores, soil and minerals. The CW-800 is equipped with a resistance furnace with quartz tube for sample oxidation and can provide temperatures up to 1000 °C. The temperature of the CW-800 can be set up in steps of 1 °C and the temperature is fixed during measurement. As common carrier gas in the CW-800 nitrogen is used.
-
Product
Ground Testing
-
Ensuring an effective earth system is essential in a telecommunications system, and Megger is expert in earth testing having been there right from the start. These days Megger offers top end systems for design and soil surveys as well as tough easy to use testers for field engineers. We have tried to make the testers self checking as much as we can, to allow you to concentrate on collating and understanding the results.
-
Product
Multi-Parameter Kits
-
Hach's multi-parameter kits check all the parameters you need—no more, no less. Each kit includes the reagents, instructions for use and a durable carrying case. The kits are suitable for either a few basic parameters (chlorine and pH) or for specific applications such as the Soil and Irrigation Water Test Kit (SIW-1).
-
Product
Earth Leakage Relay
-
Nippen Electrical Instruments Co.
NIPPEN's Earth Resistance Testers are used for measuring earth electrode resistance, soil resistance, earth continuity, neutral and earth loop resistance, resistance of various components etc.They are used in Railways, Defence, Utilities, Power Plants, Geological Surveys and other Industries.Direct reading type models SET/DET/TET provide direct readings of resistance on moving coil type meters, having a linear scale, 70mm long knife edge pointer and an external zero adjustment.
-
Product
Step & Touch & Earth Impedance
-
The kit applyed with STS 5000, STS 4000 or eKAM, allows to perform the following types of test: soil resistivity, ground grid resistance, step and touch tests and overhead lines zero sequence and mutual coupling coefficients
-
Product
pH Meter kit
MW101-SOIL
-
The Milwaukee MW101-SOIL PRO pH meter has won fans around the world with its reliable, fast operation as well as its rugged design and accuracy.
-
Product
Magnetic Resonance Equipment
SpecFIT HR60
-
Low-field Magnetic Resonance Equipment (DT-NMR) with easy-to-operate software for analysis in soil matrices.
-
Product
Soil Respiration Measurement
SRS-SD 2000
-
Truly portable soil respiration system that offers researchers superior performance for a variety of applications including spatial distribution studies. The SRS-SD 2000 offers humidity control that allows it to measure wet soils.
-
Product
Heat flux plate
HFP01
-
Hukseflux Thermal Sensors B.V.
The HFP01 heat flux plate (also called heat flux sensor) offers a solution for measuring heat fluxes. HFP01 is the world's most popular sensor for heat flux measurement in the soil as well as through walls and building envelopes. By using a ceramics-plastic composite body the total thermal resistance is kept small.
-
Product
Long-Term Systems
-
A long-term system from LI-COR lets you accomplish more with your multiplexed soil gas flux measurements. Connect up to 36 chambers to evaluate both spatial and temporal flux variation across a footprint of up to 2800 square meters.
-
Product
Earth and Resistivity Testers
-
Earth tester offering selective earth, soil resistivity, earth coupling and continuity measurements
-
Product
Moisture Meters
-
Precision Mastech Enterprises Co.
A handheld tool that measures the water content in materials like wood, drywall, concrete, and soil, typically as a percentage, to help detect hidden leaks, prevent mold, and ensure proper drying for quality control in construction, woodworking, and other industries.
