Product

4-in-1 OSLT Calibration Kit, DC to 26.5 GHz, Type-3.5 mm (m) 50 Ohm

CK520A

-

Spanawave Corporation

CK520A - Spanawave Corporation

The Network Analyzer Calibration Kits with open, short, load, and thru (OSLT) provide the RF components needed to enable stable and accurate error correct measurements. Calibration of a network analyzer using Spanawave's Network Analyzer Calibration Kits allow for precise measurements. The Calibration Kits offer broad test equipment coverage for use with the 8003 Scalar Network Analyzer as well as being compatible with most network analyzers produced by other manufacturers. Spanawave calibration kits yield complete calibrations, as it takes into consideration the three major sources of systematic error correction by one port calibration at both ports.

Product

Standard In-door Forward Optical Receiver

ONR-8636

-

Hangzhou Huatai Optic Tech. Co., Ltd.

ONR-8636 - Hangzhou Huatai Optic Tech. Co., Ltd.

ONR-8636 with standard configuration is a type of high index and universal in-door forward optical receiver. It adopts Philip optical receiving module. End-grade adopts power-doubling module. Optical connectors and RF connector can be installed at the front panel or back panel.

Product

Multi-Axis Calibrator

XM-60

-

Renishaw Inc.

XM-60 - Renishaw Inc.

XM-60 is a laser measurement system capable of measuring errors in six degrees of freedom along a linear axis, simultaneously from a single set-up. It provides a powerful diagnostic tool measuring all geometric errors in the axis from a single capture. For users of volumetric compensation XM-60 provides quick and accurate method of data population. All measurements are made optically allowing use in any orientation.

Product

Test & Calibration

-

Gamma Scientific Inc.

Gamma Scientific Inc.

Gamma Scientific is ISO/IEC 17025 accredited by NVLAP (NVLAP lab code 200823-0). In addition to assurance of measurement accuracy, accreditation ensures traceability to known standards, provides international acceptance of measured values, and is important for compliance purposes for your own ISO/IEC certifications.  Our state-of-the-art, ISO 17025 accredited calibration laboratories in San Diego, California offer a range of test and calibration services including:

Product

Multifunction Calibrators

-

Fluke Calibration

Fluke Calibration

These field and bench calibrators source, simulate, and measure pressure, temperature, and electrical signals with exceptional precision. They can automate calibration procedures, store data, and even calibrate and troubleshoot HART-compatible devices. Our bench calibrator can even be used to calibrate our field calibrators. Also find here 5.5- and 6.5-digit bench multimeters for to assist with a variety of general test and calibration applications.

Product

Rack Module with Standard Contactors with Anti-Harmonic Filters

MODF Rack

-

Lifasa - International Capacitors, SA

MODF Rack - Lifasa - International Capacitors, SA

The MODF-RACK control units include, in a compact form, all the components necessary for the operation of a step of a capacitor bank with filters. MODF-RACK modules are divided into two basic blocks: power block and control block. The two blocks are mounted in a small frame to be installed in an electrical panel.

Product

Multifunction Calibrators

-

Calmet Smart Calibration Devices

Calmet Smart Calibration Devices

Calmet offers a variety of Multifunction Calibrators including the C101, the Calpro 101, and the ZW Series.

Product

Dry Block And Bath Calibrators

-

Omega Engineering, Inc

Omega Engineering, Inc

These units are used to calibrate sensors such as thermistors, thermocouples and RTD's. Different temperature ranges, accuracies and stabilities to cover most sensor specifications.

Product

Current Calibrators

-

Valhalla Scientific Inc.

Valhalla Scientific Inc.

Used for basic measurements, tests and regulation techniques for setting and verifying test installations and instrumentation.

Product

Deskew Calibration Source for CP030, CP030A, CP031, CP031A, AP015, CP150, CP500

DCS025

-

Teledyne LeCroy

DCS025 - Teledyne LeCroy

The DCS025 Deskew Calibration Source generates time-aligned voltage and current pulses for precise deskew of voltage and current probes.This is critical for measurements in which small propagation delay differences between probes can have a large impact on a calculated measurement, e.g., instantaneous power semiconductor device loss measurements.

Product

Calibration Pulse Processor

2401

-

TESCO

2401 - TESCO

TESCO’s Calibration Pulse Processor (Catalog No. 2401) adapts to any Next Generation three phase test board to directly calibrate with three independent single phase standards.

Product

RF Electronic Calibration Module (ECal), DC/300 KHz To 9 GHz, Type-N, 2 Port

85092D

-

Keysight Technologies

85092D - Keysight Technologies

The Keysight 85092D RF electronic calibration (ECal) module makes calibration of vector network analyzers fast, easy, and accurate. ECal is a precision, single-connection calibration technique for your vector network analyzer. Performing a full two-port calibration takes less than half the time and number of connections using ECal versus mechanical calibration kits. Furthermore, the accuracy of the calibration is comparable between electronic and mechanical methods. Traditional mechanical calibrations require intensive operator interaction, which is prone to errors. With ECal, the operator simply connects the ECal module to the network analyzer and the software controls the rest.

Product

Automatic Calibration Module

ACM2543

-

Copper Mountain Technologies

ACM2543 - Copper Mountain Technologies

ACM2543 is an automatic calibration module that can be used with all CMT Vector Network Analyzers operating in frequency range up to 44 GHz. It is a fully automatic USB-controlled and powered electronic calibration module. Minimizing the number of steps required by technicians reduces the risk of human error and expedites the calibration process.

Product

Torque Calibration

-

Alliance Calibration

Alliance Calibration

ISO 17025 Accredited Calibration for Torque Screwdrivers, Torque Wrenches, Torque Multipliers, Torque Transducers, Torque Watches, and Torque Readout

Product

Standard Voltage 50 Pin D-Type Connectors for Pickering

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connectors below are suitable to use with Pickering cards and modules that utilize a standard voltage 50-pin D-type connector.

Product

NIST Calibration for D400A-AT

D400A-AT-CCNIST

-

Teledyne LeCroy

D400A-AT-CCNIST - Teledyne LeCroy

- Choice of 4 GHz or 6 GHz bandwidth models- Up to 5 Vpk-pk dynamic range with low noise- ±3 V offset range- Low loading and high impedance for minimal signal disturbance- Ideal for DDR2, DDR3, LPDDR2- Deluxe soft carrying case- Innovative QuickLink architecture- Wide variety of tips and leads-- Solder-In Lead-- Optional Positioner (Browser) Tip-- Quick Connect Lead-- Square Pin Lead-- HiTemp Solder-In Lead

Product

Dynamic Primary Transfer Standard

RD-22

-

Radian Research, Inc.

RD-22 - Radian Research, Inc.

The RD-22 Dytronic Primary Transfer Standard represents the state-of-the-art technology in a commercially available true DC to AC accuracy transfer reference. The RD-22 has typical AC measurement accuracies within the limits of traceability. Repeatability of 1 ppm can be attained at 120 V and 5 A inputs of specific models.

Product

Automatic Battery with Filters with Standard Contactors

BATLVF120

-

Lifasa - International Capacitors, SA

BATLVF120 - Lifasa - International Capacitors, SA

Accessories: Differential protection

Product

MTB Calibration Adapter

2450-CAL-30

-

TESCO

2450-CAL-30 - TESCO

The MTB Calibration Adapter (Catalog No. 2450-CAL-30)is a socket adapter that’s designed to bring phase A, B, and C current and potentials of a TESCO Multi-Position Test Board to an external RD-30 reference standard for calibration of the Test Board.

Product

Automatic Battery with Filters with Standard Contactors

BATLVF1000

-

Lifasa - International Capacitors, SA

BATLVF1000 - Lifasa - International Capacitors, SA

LIFASA automatic capacitor banks are used for centralizedcompensation of power factor in low voltage instalations.